![]() If any drives have alarm then the odds are that it is internal in the drive.Īfter power on of the control If all drives ready up except the spindle drives this is normal. Also there may be a fuse on this board that is blown.ĮMG (emergency) stop state or alarm condition Seeĭrives alarm with only the main breaker turned on(not control on)- all drives if Fanuc should have dash. ![]() Behind the panel or screen is usually a small power supply. No buttons light up on the control panel. The power supplied to the screen is often one plug with 3 or 4 larger sized wires then the rest. If the machine functions properly, then the screen is bad or power is not supplied to screen. ![]() Machine start up problems and troubleshooting tipsĬRT won't come up? Can you move the axes in handwheel after you fully power it up as if you were following any screen prompts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |